Exploration & Production Geology

E&P Geological report writing standards
Page 1 of 1

Author:  lisarag86 [ Fri Aug 10, 2012 8:25 pm ]
Post subject:  E&P Geological report writing standards


I am new here so hopefully this question has not been asked. Do you have any tips on report writing for the E&P industry. I have a report due for my internship and was wandering if there where any standards or tips I could go by.


Author:  O_Stevens [ Fri Aug 10, 2012 10:34 pm ]
Post subject:  Re: E&P Geological report writing standards

Good question, as I often see a lot of incomplete and bad reports.

I general a report should have:
-A title page and a contents page, usually followed by a list of figures and tables.

-A ‘summary’ or ‘abstract’ should be given at the beginning of the report. Along with sometimes people will give the ‘keywords’ as a quick reference to the report and its various subjects.

-The pages of the report should be numbered with arabic numerals, while the contents page(s) can be numbered with roman numerals. Pages with odd numbers should appear as right-hand side pages.

-In the case of appendices, each appendix should be given its own separate page-numbering. In larger reports, each new chapter or appendix should preferably start on a right-hand page. Each page in the report should carry the report number and the classification ‘Confidential’. On the appendix pages, the appendix number should also be present.

-The introduction should be the first chapter of the report, stating area, material, data and methods used. A ‘key map’ showing the situation of the area covered by the report can be given, e.g. on the inside front cover opposite the title page.

-Enclosures (drawings, plots) should carry a title block in the bottom right-hand corner. They should be marked with a drawing and/or serial number, and with the date and number of the report.

-On maps, geographical and grid co-ordinates should always be shown. In addition the projection system used, all defining parameters and datum should be indicated (see section 3.1). A reference length should also be drawn on the map to allow for shrinkage (e.g. a bar scale). Where appropriate, the enclosure should also carry a key map showing the area covered by the report and the enclosure.

Hope this gives you some guidance.. Good luck!

Author:  Imaged Reality [ Tue Nov 28, 2017 10:13 am ]
Post subject:  Re: E&P Geological report writing standards

You can make a good geological report without actually visiting geological forums through our virtual reality application Imaged Reality https://www.imagedreality.com/

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group